Anticorrosive Effect of Electrochemical Manganese Dioxide By-Products in Reinforced Concrete

Read  full  paper  at:http://www.scirp.org/journal/PaperInformation.aspx?PaperID=55986#.VT8jrNKqpBd

ABSTRACT

The present study investigates the effect of Electrochemical Manganese Dioxide (EMD) by-product as a replacement of cement, on durability of concrete and the corrosion protection of reinforcement steel. Reinforced cement mortars were partially immersed in 3.5% w. w NaCl solution and they were exposed to atmospheric conditions for a period of 24 months. Additions of 5% and 10% EMD byproduct were tested. The following techniques were used: half-cell potential measurements (HCP), linear polarization Resistance (LPR), mass loss of reinforcement steel, determination of carbonation depth of mortars, testing of compressive strength, total and open porosity measurements. Based on the up-to-now results of this study, the specimens with addition 10% appear smaller corrosion currents and mass loss of steel than reference specimens. Also, the compressive strength with 10% additive is appeared to be slightly higher from the reference specimens.

Cite this paper

Chousidis, N. , Rakanta, E. , Ioannou, I. and Batis, G. (2015) Anticorrosive Effect of Electrochemical Manganese Dioxide By-Products in Reinforced Concrete. Journal of Materials Science and Chemical Engineering, 3, 9-20. doi: 10.4236/msce.2015.35002.

References

[1] Nawy, E.G. (2008) Concrete Construction Engineering Handbook. 2nd Edition, CRC Press, Boca Raton.
http://dx.doi.org/10.1201/9781420007657
[2] Montemor, M.F., Simoes, A.M.P. and Ferreira, M.G.S. (2003) Chloride-Induced Corrosion on Reinforcing Steel: From the Fundamentals to the Monitoring Techniques. Cement and Concrete Composites, 25, 491-502.
http://dx.doi.org/10.1016/S0958-9465(02)00089-6
[3] Bastidas-Arteaga, E., Chateauneuf, A., Sánchez-Silva, M., Bressolette, Ph. and Schoefs, F. (2010) Influence of Weather and Global Warming in Chloride Ingress into Concrete: A Stochastic Approach. Structural Safety, 32, 238-249.
http://dx.doi.org/10.1016/j.strusafe.2010.03.002
[4] Kouloumbi, N. and Batis, G. (1992) Chloride Corrosion of Steel Rebars in Mortars with Fly Ash Admixtures. Cement and Concrete Composites, 14, 199-207.
http://dx.doi.org/10.1016/0958-9465(92)90014-M
[5] Glass, G.K. and Buenfeld, N.R. (2000) The Influence of Chloride Binding on the Chloride Induced Corrosion Risk in Reinforced Concrete. Corrosion Science, 42, 329-344.
http://dx.doi.org/10.1016/S0010-938X(99)00083-9
[6] Reddy, B., Glass, G.K., Lim, P.J. and Buenfeld, N.R. (2002) On the Corrosion Risk Presented by Chloride Bound in Concrete. Cement and Concrete Composites, 24, 1-5.
http://dx.doi.org/10.1016/S0958-9465(01)00021-X
[7] Stewart, M.G., Wang, X.M. and Nguyen, M.N. (2012) Climate Change Adaptation for Corrosion Control of Concrete Infrastructure. Structural Safety, 35, 29-39.
http://dx.doi.org/10.1016/j.strusafe.2011.10.002
[8] Ann, K.Y. and Song, H.-W. (2007) Chloride Threshold Level for Corrosion of Steel in Concrete. Corrosion Science, 49, 4113-4133.
http://dx.doi.org/10.1016/j.corsci.2007.05.007
[9] Glass, G.K. and Buenfeld, N.R. (1997) The Presentation of the Chloride Threshold Level for Corrosion of Steel in Concrete. Corrosion Science, 39, 1001-1013.
http://dx.doi.org/10.1016/S0010-938X(97)00009-7
[10] Bhargava, K., Ghosh, A.K., Mori, Y. and Ramanujam, S. (2005) Modeling of Time to Corrosion-Induced Cover Cracking in Reinforced Concrete Structures. Cement and Concrete Research, 35, 2203-2218.
http://dx.doi.org/10.1016/j.cemconres.2005.06.007
[11] Broomfield, J.P., Langford, P.E. and Paull, R.J. (1987) Cathodic Protection for Reinforced Concrete: Application to Buildings and Marine Stuctures. Proceedings of the Fourth International Conference on Durability of Building Materials and Components, Singapore, 4-6 November 1987, 654-661.
http://dx.doi.org/10.1016/B978-1-4832-8386-9.50090-5
[12] Broomfield, J.P. (2003) Corrosion of Steel in Concrete: Understanding, Investigation and Repair. 2nd Edition, E & FN Spon, London.
[13] Rakanta, E., Zafeiropoulou, T. and Batis, G. (2013) Corrosion Protection of Steel with DMEA-Based Organic Inhibitor. Construction and Building Materials, 44, 507-513.
http://dx.doi.org/10.1016/j.conbuildmat.2013.03.030
[14] Zafeiropoulou, T., Rakanta, E. and Batis, G. (2011) Performance Evaluation of Organic Coatings against Corrosion in Reinforced Cement Mortars. Progress in Organic Coatings, 72, 175-180.
http://dx.doi.org/10.1016/j.porgcoat.2011.04.005
[15] Karoglou, M., Bakolas, A., Moropoulou, A. and Papapostolou, A. (2013) Effect of Coatings on Moisture and Salt Transfer Phenomena of Plasters. Construction and Building Materials, 48, 35-44.
http://dx.doi.org/10.1016/j.conbuildmat.2013.06.050
[16] Batis, G., Pantazopoulou, P. and Routoulas, A. (2003) Corrosion Protection Investigation of Reinforcement by Inorganic Coating in the Presence of Alkanolamine-Based Inhibitor. Cement and Concrete Composites, 25, 371-377.
http://dx.doi.org/10.1016/S0958-9465(02)00061-6
[17] Johnson, C.S. (2007) Development and Utility of Manganese Oxides as Cathodes in Lithium Batteries. Journal of Power Sources, 165, 559-565.
http://dx.doi.org/10.1016/j.jpowsour.2006.10.040
[18] Panda, J.P., Sanjay, K., Ghosh, M.K. and Subbaiah, T. (2009) Electrolytic Manganese Dioxide (EMD) from Manganese Cake A Byproduct of Nodule Process. Proceedings of the 8th ISOPE Ocean Mining Symposium, Chennai, 20-24 September 2009.
[19] Brantley, F.E. and Rampacek, C. (1968) Process for Manganese Recovery from Leach Solutions. US 3397130 A.
[20] Zhang, W. and Cheng, C.Y. (2007) Manganese Metallurgy Review. Part I: Leaching of Ores/Secondary Materials and Recovery of Electrolytic/Chemical Manganese Dioxide. Hydrometallurgy, 89, 137-159.
http://dx.doi.org/10.1016/j.hydromet.2007.08.010
[21] Hellenic Organization for Standardization ELOT 1421-3 (2005) Steel for the Reinforcement of Concrete—Weldable Reinforcing Steel—Part 3: Technical class B500C. Athens.
[22] ISO/DIS 8407.3 (1986) Procedures for Removal of Corrosion Products from Corrosion Test Specimen. Genève.
[23] American Society for Testing and Materials G59-97 (2003) Standard Test Method for Conducting Potentiodynamic Polarization Resistance Measurements. Vol. 3, No. 2.
[24] Stern, M. and Geary, A.L. (1957) Electrochemical Polarization. I. A Theoretical Analysis of the Shape of Polarization Curves. Journal of the Electrochemical Society, 104, 56-63.
http://dx.doi.org/10.1149/1.2428496
[25] American Society for Testing and Materials C876-87 (1987) Standard Test Method for Half-Cell Potentials of Reinforcing Steel in Concrete. Vol. 3, No. 2.
[26] RILEM CPC-18 (1988) Measurement of Hardened Concrete Carbonation Depth.
[27] American Society for Testing and Materials C143/143M. Standard Test Method for Slump of Hydraulic-Cement Concrete. Vol. 4, No. 2.
[28] British Standard Institution BS EN 12390-3 (2009) Testing Hardened Concrete. Compressive Strength of Test Specimens. London.
[29] Washburn, E.W. (1921) The Dynamic of Capillary Flow. Physical Review, 17, 273.
http://dx.doi.org/10.1103/PhysRev.17.273
[30] Kanellopoulos, A., Petrou, M.F. and Ioannou, I. (2012) Durability Performance of Self-Compacting Concrete. Construction and Building Materials, 37, 320-325.
http://dx.doi.org/10.1016/j.conbuildmat.2012.07.049
[31] Theodoridou, M., Ioannou, I. and Philokyprou, M. (2013) New Evidence of Early Use of Artificial Pozzolanic Material in Mortars. Journal of Archaeological Science, 40, 3263-3269.
http://dx.doi.org/10.1016/j.jas.2013.03.027
[32] Mansfeld, F. (1977) An Evaluation of Polarization Resistance Measurements. Materials and Corrosion, 28, 6-11.
http://dx.doi.org/10.1002/maco.19770280103
[33] Angst, U., Elsener, B., Larsen, C.K. and Vennesland, O. (2009) Critical Chloride Content in Reinforced Concrete—A Review. Cement and Concrete Research, 39, 1122-1138.
http://dx.doi.org/10.1016/j.cemconres.2009.08.006
[34] Neville, A.M. (1981) Properties of Concrete. Longman Scientific & Technical, Pitman Publishing, London.
[35] Katsioti, M., Tsakiridis, P.E., Agatzini-Leonardou, S. and Oustadakis, P. (2005) Examination of the Jarosite-Alunite Precipitate Addition in the Raw Meal for the Production of Portland and Sulfoaluminate-Based Cement Clinkers. International Journal of Mineral Processing, 76, 217-224.
http://dx.doi.org/10.1016/j.minpro.2005.01.007
[36] Suryavanshi, A.K., Scantlebury, J.D. and Lyon, S.B. (1996) Mechanism of Friedel’s Salt Formation in Cements Rich in Tri-Calcium Aluminate. Cement and Concrete Research, 26, 717-727.
http://dx.doi.org/10.1016/S0008-8846(96)85009-5
Advertisements

发表评论

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / 更改 )

Twitter picture

You are commenting using your Twitter account. Log Out / 更改 )

Facebook photo

You are commenting using your Facebook account. Log Out / 更改 )

Google+ photo

You are commenting using your Google+ account. Log Out / 更改 )

Connecting to %s